Page 52 - ITAtube Journal 2 2026
P. 52

Press releases
tube stock – 4.1 kg
hot forged preform– 4.1 kg
lost material
0.8 kg
hollow drive shaft– 3.3 kg
Fig. 2: Hollow drive shaft made from tube - CAD
Fig. 2: Hollow drive shaft made from tube - CAD
Fig. 3: Hollow drive shaft made from tube –
realized component
Fig. 3: Hollow drive shaft made from tube – realized component
tube stock – 3.3 kg
partial radial swaged, wall thinned tube– 3.3 kg
hot forged preform– 3.3 kg
lost material
0.8 kg
lightweight drive shaft– 2.5 kg
A comparison of a one-piece automotive
drive shaft, focusing on material input and
weight is demonstrated in Fig. 1, Fig 2 and
Fig. 4:
Even today, drive shafts are often machined
from solid bar. In the present example, the
required blank weight is 9 kg of high-grade
quenched and tempered steel. Despite a
material removal rate of more than 30%,
the resulting weight still remains high.
In addition, the directly associated energy
consumption and CO₂ emissions are high.
Therefore, particularly for high-volume
components forming operations should
be used instead. Fig 2 shows the same
part of Fig. 1, but now using appropriate
tube material in combination with forming
operations for local thickening and end
reduction. The initial blank weight of the
drive shaft can be reduced to more than
50% (4.1 kg)
As a result of the hollow near-net-shape
design, both, the fi nal component weight
and the material waste are signifi cantly re-
duced. Additional machining by subsequent
drilling to create the hollow section inside is
eliminated entirely. Fig. 3 shows lightweight
drive shaft (link shaft) manufactured from
tube and formed by hot forging with fi nal
machining.
If required, additional material and weight
savings can be achieved by applying ad-
ditional forming operations. The central
section of the shaft serves solely for torque
transmission and can therefore be de-
signed with a reduced wall thickness. This is
made by prior partial wall thinning - using
rotary swaging and elongation over man-
drel - without generating additional chips or
material waste. (Fig. 4)
By combining cold and hot forming pro-
cesses the component weight can ultimate-
ly be reduced to as little as 2.5 kg in this
example, without losing any functionality.
Despite this substantial weight reduction,
machining-related material losses are re-
duced by more than half. Even a welded 2-
or 3-piece design cannot achieve a higher
degree of weight or material savings for a
component of this type.
Fig 4. Lightweight drive shaft made from wall
thinned tube
Fig 4. Lightweight drive shaft made from wall thinned tube
52 ITAtube Journal September 2026




























   50   51   52   53   54